We are now stocking a few new items in the trauma room wall racks near bed 3 behind the nursing station.
We have both the T-POD as well as pean clamps for sheet binding if preferred. For those unfamiliar with T-POD application, here is a video tutorial
for review. In addition I have a trainer and will happy to inservice anyone interested.
Tourniquets are also now available. Pretty self explanatory but Here
are a couple of videos regarding application of tourniquets. I’ve also attached a scan of the product insert with instructions.
QuiKClot Combat Gauze
QuikClot is a kaolin impregnated gauze pad that allows for topical hemostasis by activating factor VII. It is clay based and unlike prior formulations of quikclot does not result in exothermic reaction and has not been found to be associated w/ allergic reaction. It can be used in any situation in which you encounter difficult to control bleeding, eg. proximal injuries you are unable to tourniquet, avulsion injuries, oozing from vascular access sites including shunts, oozing from scalp wounds, etc. If hemorrhage control is unsuccessful after application, leave the initial pad in place and apply another to minimize disrupting existing clot. The gauze can be left in place for 24 hours but once dried should be soaked with saline prior to removal.
The following tutorial is courtesy of Dr. Colleen Smith.
Transvenous pacing trays and pacing generator are located in the green cabinets above the sink in the Cardiac Room.
- Transvenous Pacing Electrode Tray containing:
- TVP catheter
- Percutaneous sheath introducer w/ syringe/guidewire/dilator
- Sterile sleeve
- 2 adapter pins
- Alligator clamp
- 3ml syringe that stops at 1.5ml
- Pacing generator box with extension connecting cable (attached to the box)
- Central line bundle with sterile patient drape, and sterile gown
- Sterile gloves
- Ultrasound machine with linear probe and sterile ultrasound probe cover,
Set up pacing generator box
- Turn generator box on by pressing the on button. Insert a new battery if necessary.
- Set the mode or sensitivity to demand or asynchronous pacing
- Set rate control above the native rate or the transcutaneous pacing rate usually around 80bpm
- Turn V (ventricular) output control to the max mAmps (usually 20-25mAmps)
Placement (Under sterile field with large patient drape, sterile gown, gloves, etc.)
- Place sheath introducer as you would place a Cordis type of central line, confirm venous placement with ultrasound and suture in place.Preferred site: Right internal jugular. Secondary site: Left subclavian (Try to save this for permanent pacemaker if possible.)
- Connect the pacing extension cable(s) to the pacing generator box.
- Connect the proximal lead of the pacing catheter to the positive (+) port of the pacing extension cables (or generator box
- If using ECG to guide placement: Connect the distal or negative (-) lead of the pacing catheter to the V2 attachment of the monitor or ECG machine using the alligator clip in the TVP catheter kit. This lead will now display an ECG waveform based on input sensed by TVP catheter as you place it. *See image below
- Thread the STERILE SLEEVE over the TVP catheter PRIOR to inserting the catheter into the introducer. (Keep the sleeve collapsed and pull it far back.) The TVP catheter should go through the blue end of the sleeve first so that the green end of the sleeve can connect with the sheath introducer.
- Place the TVP catheter – oriented so that it curves toward the heart.
- If using the balloon (optional):
- Only use the syringe that comes in the kit.
- Check the balloon for leaks by inflating it prior to inserting the catheter.
- Inflate the balloon when you have inserted to about 20cm (2 slender dashes on the catheter) and lock it in that position prior to advancing the catheter
- ALWAYS deflate the balloon and lock it down prior to retracting the TVP catheter.
- Correct placement should occur between 30 and 40cm, consider measuring with TVP catheter over the patient’s chest prior to placing.
- If you have gone too far, DEFLATE the balloon and retract the TVP catheter back to the 5-10cm mark, reinflate the balloon (if using) and reinsert the TVP catheter.
- Confirm capture with:
- ECG waveform attached to negative lead of TVP wire (injury pattern, see attached images)
- Capture on monitor (LBBB with ST elevation at set rate)
- Cardiac ultrasound (wire visible in right ventricle)
- When you have capture. Deflate the balloon and lock it closed. Insert the TVP catheter another 5-10mm.
- Secure the green end of the sterile sleeve to the introducer. (This should hold the TVP catheter in place). Pull sleeve open fully and secure the blue end of the sterile sleeve to the TVP catheter. (This ensures continued sterility of the portion of the TVP wire within the sterile sleeve so that it can be adjusted.)
- Apply sterile dressing to the introducer insertion site
Procedure Completion (You can now break sterile field)
- Connect the distal lead of the TVP catheter to the negative (-) input of the generator box (if not already done.)
- Remove the syringe for the balloon and tape it to the wire.
- Adjust mAmps by decreasing the ventricular mAmps until you loose capture and then go up x2 (or 20% higher than your lowest capture number)
- Obtain a CXR to further confirm placement and location, check for pneumo- or hemothorax.
- Obtain a 12 lead ECG to confirm pacing spikes and widened QRS for every beat.
- Same as any central line: pneumothorax, improper placement, arterial placement, etc.
- Valve rupture or tear. Caused by retracting the TVP catheter with inflated balloon. Detect by new murmur, acute heart failure, echo.
- Perforation of the LV causing tamponade. Detect by sudden hypotension with narrow pulse pressure, pericardial effusion on echo. DO NOT REMOVE TVP Catheter.
- Pulmonary artery rupture or tear. Caused by inflating the balloon in the pulmonary artery. Results in tamponade physiology.
- Septal wall perforation. Caused by pushing the TVP catheter through the septum. Results in left to right shunt physiology, acute right heart failure, hypoxia
Below is a tutorial put together by Mount Sinai Alumni Anita Vashi
Transvenous pacing ppt
EMRAP put together a video tutorial of the process with a different model of pacemaker
The revised massive transfusion and emergency release forms for uncrossmatched product are now stocked in the trauma room and available for download from the GUIDELINES page.
With the revised MTP form, the delivery schedule has now been replaced by a fixed ratio of 5U PRBCs, 4U FFP, and 1U single donor platelets. 2 Pooled cryoprecipitate (equivalent to 10U of cryo) will be added to every 3rd delivery of product. You may also request FEIBA, Kcentra, or other blood product as needed.
In addition, in situations in which a patient is not rapidly exsanguinating and you don’t expect you will need multiple deliveries, you can also obtain smaller quantities of uncrossmatched blood product just as quickly with the emergency release form. As a reminder, 1U of single donor/apheresis platelets is equivalent to ~5U of pooled platelets.
In both cases, call 4-2028 and send a runner with the signed forms affixed with a patient label to the blood bank to pick up the product.
MASSIVE TRANSFUSION FORM - 7.19.17
EMERGENCY BLOOD PRODUCT RELEASE - 7.19.17